Skip to main content

Installation

Before installation

Read this manual carefully before installing and operating the SMD3. Observe the following safety instructions.

Qualified personnel

All work described in this document may only be carried out by persons who have suitable technical training and the necessary experience or who have been instructed by the end-user of the product.

Without proper training and necessary experience, damage to the equipment or personal injury might result.

Additional safety and warning notices

Danger of electric arcing! Never plug or unplug any connector while powered. Plugging or unplugging a motor while powered may damage or destroy the driver output stages.

Unpacking

On receipt of the instrument remove all packing material and check that all items on the delivery note have been received. Report any damage or shortages to the company or distributor who supplied the instrument. The packing material has been specially designed to protect the instrument and should be retained for possible future use.

Mechanical installation

The SMD3 may be mounted via the front panel and or underside flanges, in any orientation. Forced air ventilation is not required. The ambient operating temperature range is 10 °C to 60 °C.

Connecting

Rear panel

rear panel new all.png

X1 - Power

X2 - Motor

X3 - I/O

X4 - Thermocouple

X5 - USB

Front panel

X6 - Joystick

Motor wiring

Overview

Lead identification

Note regarding reversal of rotation

Wiring motor to the vacuum feedthrough

Wiring between drive and vacuum feedthrough