Installation

Before installation

WARNING: Read this manual carefully before installing and operating the SMD4. Observe the following safety instructions.

Qualified personnel

WARNING: All work described in this document may only be carried out by persons who have suitable technical training and the necessary experience or who have been instructed by the end-user of the product.

WARNING: Without proper training and necessary experience, damage to the equipment or personal injury might result.

DANGER: Danger of electric arcing! Never plug or unplug any connector while powered. Plugging or unplugging a motor while powered may damage or destroy the driver output stage.

Additional safety and warning notices.

Unpacking

On receipt of the instrument remove all packing material and check that all items on the delivery note have been received. Report any damage or shortages to the company or distributor who supplied the instrument. The packing material has been specially designed to protect the instrument and should be retained for possible future use.

Mechanical installation

The SMD4 is freestanding instrument. It does not require mounting. Forced air ventilation is not required. The ambient operating temperature range is 10 °C to 60 °C.

Connecting

Same ideas smd3

See mech of ds for smd4 connectors etc.

All the text about IMO connectors goes, as smd4 does not have them. see rb for pinouts

power - per smd3 manual with changes: fixed 48 v per datasheet, statement about  max 67 goes because smd4 is for fixed 48v, blue info bit goes.

The rest just copy per smd3, but with substitute the new connectors

No thermocouple connector as now in motor connector, so move that section there

There are new connectors; 2 x rj45 for rs232/485 and 1 x rj45 for ethernet. Leave template sections for now.

Motor wiring; all change, leave empty section for now

Lead identification stuff remains same, as does wiring, cable stripping beads, cable requirements etc, rb to edit once template is in