Firmware Update Troubleshooting

Bootloader could not connect error.

If you receive a “Bootloader could not connect” error when updating your device, follow the steps below.

1. Make sure the device is connected to a USB 2.0 port. There have been some unresolved issues with reliability when updating via a USB 3.0 port, particularly with certain driver versions.

2. Ensure your device has the correct drivers installed, this can be done by going onto device manager whilst the error message has appeared.

If the device appears like below, Reinstall the Device Control software. This will also reinstall the drivers required to update the device. During installation, make sure the driver installation checkbox is selected. After reinstalling the software, retry the firmware update process. 

3.

Wrong driver selected error.

 

If reinstallingyou receive a “Wrong driver selected” error when updating your device, follow the softwaresteps andbelow.

drivers does not resolve the issue, start the firmware update again and stop when you reach the following message:

 ThenWhile checkthe iferror windowsmessage is selectingdisplayed go to Windows device manager and find the correctdevice. drivers in device manager.

It shouldwill appearbe listed as a STM32 BOOTLOADER device.

If it doesn't appear with STM32 BOOTLOADER and appears with STM Device in DFU Mode,.

 

Right-click on the device > properties > update driver.

Select 'Browse my computer for drivers' > 'Let me pick from a list available drivers on my computer'. Select STM32 BOOTLOADER and click next. Restart your device and Device Control software and try to update again.

 

It should now appear as a STM32 BOOTLOADER device.

Restart your device and the Device control software and try updating the device again.